Training Documents for Falco Dealers and Customers

Dealer application can be found here.

Spoking Information:

For Spoking Hx 2.0 500W Motors, review the following documents:

500W Front Wheel Installation with 100 mm Spacing: 
http://falcoemotors.com/dealers/500W%20Front%20Wheel%20Installation.jpg

500W Rear Wheel Installation with 135mm Spacing:
http://falcoemotors.com/dealers/500W%20Rear%20Wheel%20Installation.jpg

For Spoking Hx 3.0 750W Motors, review the following documents:

750W Front Wheel Installation with 100 mm Spacing: 
http://falcoemotors.com/dealers/750W%20Front%20Wheel%20Installation.jpg

750W Rear Wheel Installation with 135mm Spacing:
http://falcoemotors.com/dealers/750W%20Rear%20Wheel%20Installation.jpg

For Spoking Hx 4.0 1000W Motors, review the following documents:

1000W Front Wheel Installation with 100 mm Spacing: 
http://falcoemotors.com/dealers/1000W%20Front%20Wheel%20Installation.jpg

1000W Rear Wheel Installation with 135mm Spacing:
http://falcoemotors.com/dealers/1000W%20Rear%20Wheel%20Installation.jpg

 Troubleshooting the motor:

In a rare instance where motor is not working with throttle or torque sensor or crank sensor, the following things should be checked:

1. Is motor receiving power? How do you check that? Check voltages on the 6-pin and 4-pin motor connectors. 6-pin connector voltages are documented here. 4-pin connector voltages are documented here. Also, make sure the battery connector is installed as per this document. Check to make sure battery fuse is not blown and the battery connector is outputting correct voltage. Motor will not work beyond 55V as an internal safety mechanism.
2. Is motor locked? If the wheel is stiff to rotate, the motor is most likely locked. It should be unlocked using the console or the Falco Interface. If motor is locked, some versions of Falco Interface (1.4.2 or lower) will show the Hall Code (Err) as 255.
3. Is motor in mode 0. If the connected console or the Falco interface is in mode 0, motor is automatically in non-assist mode.

Hx Motor Wiring Diagram can be downloaded here. (Note: A number of brake sensors can be interfaced with the Hx motor. The 6-pin connector has the default provision to connect to a brake sensor (for OEM applications). Also, crank sensor connection can be reprogrammed to act as a brake sensor or reverse function).

Falco Interface :

Falco interface serves two main purposes: one to adjust the torque sensor settings and secondly to diagnose any issues with the motor and the console. The third and least used purpose is to be used as a way to connect to an ANT+ heart rate sensor while using the bike as an indoor exercise machine.

Falco Interface 1.4.2 version can be downloaded here. How to use Falco Interface? The YouTube videos can be seen here: Part 1 and Part 2. You can also review this video published by Court Rye of Electric Bike Review.

 How does Falco Torque Sensor work?

Review this document.

Falco Quick Start Installation Guide

Falco Quick Start Guide can be found here.

Falco's Simplified Console for US Customers

Learn about Falco's simplified console here.

 Other Dealer Training Documents

http://falcoemotors.com/dealers/dealer_training_documents.zip

Images for Your Website

http://falcoemotors.com/dealers/Dealer_Photos.rar

 http://www.falcoemotors.com/?page_id=43

Falco Press Images